![]() ![]() When I cross them on my “home-made cable” before going to the straight through DB9 extension I get no communication at all from the panel and when I hook up to vera it freeze on loading lua engine. I have tried pinning the cable reversing the TX-RX, CTS-RTS but that appears to be in correct for my setup as I seem to get some communication from my panel without crossing them. I used a straight through cable and a prolific usb to serial adapter to connect to vera. ![]() I cut it and pinned it according to the instructions on the physical connection post. I couldn’t find the recommended cable so I found a IDC 2x5 to DB9 connector that was pinned 1-1. ![]() So now for the fun, get it working with vera. There is no shortage of folks on here with that setup working. None the less I returned it and bought a NX-8e to make matters more simple. He thought there were two firmwares being burned to the units and one was compatible and the other only works with the NX-8V2. Interlogix told me that unit is not supported despite the fact that their documentation says it will work. ![]() To make a very long story short, that isn’t going to work. I started with a NX-6V2 and folks on the forum indicated I could buy a NX-584e and use it to connect to my vera controller. Forgive the long post but I want to give you as much information as possible. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |